to convert uk prices to euro, or any other currency,please use the easy to use currency converter located on the previous page.
payment can be made with VISA and MASTERCARD.
TOOLS FOR :--
FRONT BRAKES
REAR BRAKES
STEERING MECHANISM
FRONT DRUM REMOVAL
REAR DRUM REMOVAL
TOP BALL JOINT
BOTTOM BALL JOINT
OUTER TRACK ROD END
INNER TRACKROD END
BRAKE CENTRALISERS
SLIDE HAMMERS
HUB LOCKING BARS
SPECIAL SOCKETS
ETC,ETC,ETC,ETC.
Special tools
2CVTOOLS MAKES AND DISTRIBUTES MOST OF THE SPECIAL TOOLS NEEDED TO REPAIR AND MAINTAIN YOUR HY VAN.
Scroll down to see some tools.
Front wheel bearing extractor ORDER CODE HY022 
Price £110 ORDER CODE HY022
_________________________________________________________________
Front brake slave cylinder ORDER CODE HY023
Phosphor Bronze Pistons Price £100 for set of 4
Pistons sent as STANDARD SIZE.
Oversize pistons made and fitted to each individual cylinder.
Old cylinders are honed out and piston made to suit.
ONLY APPLIES IF CYLINDER IS RECLAIMABLE.
Honing costs £20 per cylinder.
Rear cylinders can also be reconditioned.
New seals and dust covers supplied with finished product.
Please send your old cylinders and pistons for reconditioning
_________________________________________________________________
ORDER CODE HY01 BOTTOM BALL JOINT TOOL
THIS IS THE TOOL FOR UNSCREWING THE INTERNAL LOCKING RINGNUT UP
INSIDE THE LOWER BALL JOINT CASTING.THERE ARE 4 PEGS TO LOCATE IN THE RINGNUT.WHEN THE RINGNUT IS TIGHTENED UP, IT IS PEENED AGAINST THE INTERNAL THREADS TO LOCK IT IN POSITION. THE RINGNUT IS TIGHT TO GET OUT, SO CARE MUST BE TAKEN WHEN UNSCREWING IT SLOWLY.YOU WILL NEED TO USE A 1/2" RATCHET ON THE END OF THIS TOOL.
Price = £35.50 uk
____________________________________________________
ORDER CODE HY02 FRONT BRAKE ADJUSTER SOCKET
THIS TOOLS HAS A SLOT IN IT TO FIT ONTO THE FRONT BRAKE ADJUSTERS.
THE ADJUSTERS ARE AT THE BACK OF THE DRUM,TOP AND BOTTOM AND YOU WILL NEED A 1/2" RATCHET FOR THIS TOOL.
Price = £17.00uk
____________________________________________________
ORDER CODE HY03 FRONT BRAKE SHOE CENTRALISER
THIS TOOL MEASURES THE INSIDE DIAMETERS OF THE BRAKE DRUMS.
YOU THEN TRANSFER THE MEASURED SIZE TO THE BRAKE SHOES AND CENTRALISE THEM.YOU WILL NEED OTHER TOOLS TO ADJUST THE ECCENTRICS AND OUTER ADJUSTERS TO CENTRALISE THE SHOES CORRECTLY. IF SHOES ARE NOT SET CORRECTLY,THEY WILL BE IN-EFFECTIVE IN STOPPING YOU,WEAR UNEVENLY AND SQUEAL.
Price = £105 uk.
____________________________________________________
ORDER CODE HY04 TRACK ROD END [OUTER] BOTTOM NUT TOOL
USE THIS TOOL TO PUT THE BOTTOM PLUG SCREW INTO THE OUTER TRACK ROD END HOUSING.WHEN INSTALLING A NEW TRACK ROD BALL JOINT,TAKE THE SCREW UP TO ITS LIMIT,THEN BACK-OFF 1/6 TURN.THIS WILL GIVE THE UNIT ITS SPRING LOADED EFFECT.
Price = £25.00 uk
____________________________________________________
ORDER CODE HY05TAP FOR BOTTOM BALL JOINT THREADS
YOU WILL NEED TO MAKE GOOD ANY DAMAGED THREADS INSIDE THE BOTTOM BALL JOINT HOUSING WITH THIS TOOL. THEY BECOME DAMAGED BECAUSE OF THE INTERNAL RING NUT BEING PEENED INTO ITS FINAL POSITION.THE TAP IS 40MM X 1.5MM THREAD.
Price = £53.00
________________________________________________________________________________________
ORDER CODE HY06SOCKET FOR THE ECCENTRIC BRAKE ADJUSTERS
INSIDE THE FRONT BRAKE DRUM ARE 2 ECCENTRIC ADJUSTERS.YOU WILL NEED THIS TOOL TO HELP CENTRALISE THE BRAKE SHOES.
Price = £20.00 uk
____________________________________________________
ORDER CODE HY07MANDREL TO PUSH OUT REAR BRAKE DRUM BEARING.
USE THIS TOOL ON A PRESS TO TAKE OUT A BEARING FROM A REAR BRAKE DRUM.
Price = £30.00 uk
_______________________________________________________________________________________
ORDER CODE HY08LOCKING BAR FOR BRAKE DRUMS.
TO UNDO FRONT DRIVE SHAFT AND REAR HUB NUTS USE THIS LOCKING BAR ON THE BRAKE DRUM WHEEL STUDS AND JAMB IT ON THE GROUND.THE LOCKING BAR IS OVER 1 METER LONG.
Price = £25.00 uk
___________________________________________________
ORDER CODE HY09SLIDE HAMMER TO REMOVE FRONT BRAKE DRUM
THE FRONT BRAKE DRUMS CAN BE DIFFICULT TO REMOVE. USING THE SLIDE HAMMER MAKES THIS JOB EASY. THERE ARE 3 FIXING BOLTS TO ATTACH THE TOOL TO THE BRAKE DRUM. REMEMBER TO TAKE OUT THE 6 SCREWS LOCATED INSIDE THE DRUM WHICH SECURE A PLATE HOLDING THE WHEEL BEARING IN ITS HOUSING.
Price = £68.00 uk
____________________________________________________
ORDER CODE HY10
TOP BALL JOINT SOCKET.
Price = £32 UK
_________________________________________________________________
ORDER CODE HY11
55mm SOCKET FOR REAR HUB NUT [3/4" DRIVE]
PRICE = £50.75
_____________________________________________________________________________________
ORDER CODE HY12
60mm IMPACT SOCKET
FOR REAR AXLE SWINGING ARM REPAIR
SWINGING ARM HAS TO BE TAKEN OUT OF VEHICLE AND DISMANTLED TO REPLACE WORN OUT TAPER ROLLER BEARINGS AND OIL SEALS.---------ALL PARTS AVAILABLE FROM THIS SITE.
PRICE = £55.75 UK
__________________________________________________________________
ORDER CODE HY13
46mm DEEP IMPACT SOCKET FOR CRANKSHAFT NUT
PETROL VAN ONLY
PRICE = £45.75 UK
________________________________________________________________________________________
ORDER CODE HY14
38mm SOCKET FOR DIESEL CRANKSHAFT NUT AND FRONT WHEEL HUB NUT
PRICE = £29.75 UK
_______________________________________________________________________________________
ORDER CODE HY15
13mm OFFSET SPANNER FOR REAR NUT ON CARBURETTOR
PRICE = £24 UK
________________________________________________________________________________________
ORDER CODE HY16
OPEN JAW SPANNER FOR ALUMINIUM CAP NUT AT END OF STEERING RACK UNIT
PRICE = £28.50 UK
__________________________________________________________________
ORDER CODE HY17
OPEN JAW 80mm SPANNER FOR REAR BRAKE DRUM GREASE CAP NUT.
PRICE = £25 UK
________________________________________________________________
ORDER CODE HY18
SPECIAL SOCKET TO UNDO THE SCREWS HOLDING THE GEARBOX CASING TO THE ENGINE ON PETROL VEHICLES ONLY.
PRICE = £20.00 UK
__________________________________________________________________
ORDER CODE HY19
34mm x 1.5mm pitch TAP
USED TO RECLAIM OR CLEAN UP THE THREADS INSIDE THE OUTER TRACK ROD END CASING.
PRICE = £48.75
__________________________________________________________________
ORDER CODE HY20
2 SPECIAL SOCKETS TO ADJUST PLAY IN THE STEERING RACK INNER BALL JOINTS.
1 SOCKET HAS 2 TEETH AND THE OTHER HAS 4 TEETH.
THE SMALLER SOCKET FITS INSIDE THE LONGER ONE.
PRICE = £44.50 UK
__________________________________________________________________
ORDER CODE HY21 FRONT SUSPENSION
SPECIAL PEG SPANNER FOR UNDOING THE 4 SLOT NUTS ON THE UPPER WISHBONE.
PRICE = £38.75
__________________________________________________________________